User manual

Universal Remote Control URC 1001
30 - English
Teletext Mode
Use the TTX/MIX button (31) to switch to Teletext
mode. Press the TTX/MIX button (31) again to exit
Teletext mode.
Depending on the device that you use for Teletext
reception, the mixed mode will appear first. In this
case you must press the TTX/MIX button (31) a
third time to switch Teletext off.
The following buttons are available for Teletext
control:
(3) Direct input of the Teletext page via numeric
buttons
(24) Toggle to the next Teletext page
(25) Toggle to the previous Teletext page
(5) Stop page scan
(6) Mix Teletext and TV picture
(20) Disable Teletext
Child lock
The child lock function lets you block the numeric
keypad (3) and the buttons CH+ (24) and
CH- (25). This will avoid that channels can be
switched. The child lock can be enabled and
disabled for each source device selection button
individually.
Proceed as follows to enable or disable child lock:
 Press and hold the SET button (21) for at least
3 seconds. The display shows [CODE SETUP].
Then release the SET button (21).
 Press
(8). The display shows
[CONFIGURE].
 Press the OK button (22). The display shows
[TIME SETUP].
 Press
(8) twice. The display shows
[KIDS LOCK].
 Press the OK button (22). The display shows
[TV OFF].
 Press the source device selection button for
which you want to enable or disable the child
lock function.
 Press
or (8) to toggle between [ON] (child
lock enabled) or [OFF] (child lock disabled).
 Press the OK button (22). The message
[SUCCESS] will appear for a few seconds and
the device returns to the [KIDS LOCK] level.