User manual

Universal Remote Control URC 1001
24 - English
If you want to use the TV for sound output again,
repeat the above steps by using the TV source
selection button (2) in the first step.
Programming VPT Manually
If you want to control the volume of a specific
device individually (not using VPT), this must be
programmed manually.
Example:
You are using the remote control for a satellite
receiver too. For all devices, VPT controls the
volume via the TV set, but the sat receiver has its
own volume control that you want to use.
For manual programming, proceed as follows:
 Press and hold the SET button (21) for at least
3 seconds. The display shows [CODE SETUP].
Then release the SET button (21).
 Press
(8) three times. The display shows
[VPT SETUP].
 Press the OK button (22). The display shows
[TO DEV].
 Press the source device selection button (2) of
the device for which you want to override the
volume control (e.g. STB). The display shows
[FROM DEV].
 Press the source device selection button (2) of
the device that you want to use for volume
control (in this example also STB). The
message [SUCCESS] will appear for a few
seconds and the device returns to the
[VPT SETUP] level.
 Quit the process by pressing the EXIT button
(23).
Please note that using VPT overrides any
manually-learned key functions.