User manual

Universal Remote Control URC 1001
English - 19
Macros
Macros allow you to execute up to 16 button
commands in sequence by just pressing one
single button. The used buttons may correspond
to multiple devices.
For instance, can press just one single button to
perform the following operations:
 Power-up the TV set
 Switch the TV set to the DVD player input
source
 Power on the DVD player
 Start DVD playback
Programming a Macro
 Press and hold the SET button (21) for at least
3 seconds. The display shows [CODE SETUP].
Then release the SET button (21).
 Press
(8) three times. The display shows
[MACRO].
 Press the OK button (22). The display shows
[MACRO1].
If necessary, press the or (8) button to
select another sequential macro number to
save your macro. You can use the presets
Makro1 to Makro6 for saving.
 Press the OK button (22). The display shows
[SET UP].
If you have chosen a preset and there is
already a macro stored under this position, the
message [MAKRO HAS] will be displayed.
 Press the OK button (22). The last selected
device type will show on the display.
 First enter the source selection button of the
device that you want to execute the first
command. To do this, press the corresponding
source selection button (2).
 Press one or more buttons in sequence whose
functions shall be executed. You can execute
up to 16 commands in the same macro.
If you want to execute a function for a different
device, first press the corresponding source
device selection button (2). Switching the
device will diminish the number within the 16
programmable commands.