User manual

Universal Remote Control URC 1001
16 - English
releasing the button, the message [SUCCESS]
or [FAIL] appears on the display.
 If you see the message [SUCCESS], the
command has been programmed successfully.
If necessary, you may repeat the last two steps
to copy another command and assign it to a
different button.
 If you see the message [FAIL], the command
could not be programmed. Repeat these steps
with the same button, but keep it pressed
longer.
 After all the desired buttons have been
programmed, quit the programming mode by
pressing the EXIT button (23).
It is not possible to exit programming while the
universal remote control is still waiting for a
command to be sent from the original remote
control (the display shows [WAITING]).
 Quit the programming mode by pressing the
EXIT button (23) three times.
Erasing a Key Code
You may erase a learned key code without
altering any of the other programmed functions.
 Press the source device selection button (2) of
the device for which you want to edit the
programmed information.
 Press and hold the SET button (21) for at least
3 seconds. The display shows [CODE SETUP].
Then release the SET button (21).
 Press (8) twice. The display shows
[LEARNING].
 Press the OK button (22). The display shows
[LEARN KEY].
 Press
(8). The display shows
[DELETE KEY].
 Press the OK button (22). The display shows
[SELECT KEY].
 Press the button whose function you want to
erase. The message [SURE DELET] will
appear on the display.
 Press the OK button (22) to confirm the
deletion.
 The message [DELETED] will appear for a few
seconds and the device returns to the previous
menu [SELECT KEY].