User manual

Universal Remote Control URC 1001
English - 15
Learning Function
For this you must have the original remote control
unit of the device you want to program, and this
remote control unit must be working properly.
The learning function lets you have the original
remote control unit teach the different button
functions to your new universal remote control.
This lets you add or edit any specific buttons that
do not work properly when using a preset device
code or control a device whose device code is not
available.
Learning a Key Code Signal
Place the original remote control unit of the device
with its transmitter side (front) facing towards the
universal remote control (see figure). The
optimum distance is between 0.5 and 2 inches
(0.5cm to 5cm).
In very rare cases, the specified distance is too
large. If the programming cannot be completed
successfully, reduce the distance between the two
remote controls and try it again.
 Press the source device selection button (2) of
the device you want to program.
 Press and hold the SET button (21) for at least
3 seconds. The display shows [CODE SETUP].
Then release the SET button (21).
 Press
(8) twice. The display shows
[LEARNING].
 Press the OK button (22). The display shows
[LEARN KEY].
 Press the OK button (22) again. The display
shows [SELECT KEY].
 Press the button that you want to assign on the
universal remote control. The display shows
[WAITING].
 Press and hold down the button on the original
remote control which you want to copy the
signal from for at least 3 seconds. After