User manual

Universal Remote Control URC 1001
14 - English
If you have pressed the PAUSE button (12) too
late, you can use the button (8) to return
step by step to the previous device codes to
check them again. If these device codes do not
work, you can use the button (8) to go back
to the device code where the scan was
stopped. As soon as the TV set powers back
on, the proper device code has been found.
 Press the OK button (22) to save the device
code. The message [SUCCESS] will appear for
a few seconds and the device returns to the
previous menu [AUTO SRCH].
 Quit the programming mode by pressing the
EXIT button (23) twice.
If the TV set fails to respond properly, repeat the
automatic search. Then skip the already-setup
device code. You may for instance cover the
remote control transmitter at the front of the
remote control when the wrong code number is
going to be sent.
It is possible that no proper device code is found.
In this case, try to program the remote control by
using the learning function (see page 15) and the
original remote control unit (if you still have it).