User manual

Universal Remote Control URC 1001
English - 13
Searching for Device Codes automatically
This method will scan all device codes for the
selected device type. This may take a very long
time and should be used only if the above
methods do not succeed.
Power on the device for which you want to
program the remote control. If your device is a
VCR or a CD or DVD player, please also insert a
tape or CD/DVD.
To cancel the following programming at any time,
press EXIT (23) to return without saving any
changes. Press the EXIT button (23) multiple
times until the remote control has returned to
standard mode.
Press PAUSE (12) to cancel programming at any
time. Press PAUSE (12) again to resume the
programming from the same point.
Proceed as follows to search for the device code
automatically (this example refers to programming
a TV set).
 Point the remote control to the TV set while
entering the commands.
 Press and hold the SET button (21) for at least
3 seconds. The display shows [CODE SETUP].
Then release the SET button (21).
 Press the OK button (22). The display shows
[BRAND SRCH].
 Press
(8). The display shows
[AUTO SRCH].
 Press the OK button (22). The last selected
device type will show on the display. The
device code below it reads "0001".
 Press the source device selection button of the
device you want to program. In this example, it
is the TV button (2). The display shows [TV].
 Make sure that the TV set has been powered
on and that the remote control points towards
the TV set.
 Press OK (22) to start the search. The remote
control will send a signal from each preset
device code.
 As soon as the TV set powers off, press the
PAUSE button (12). This will interrupt the
automatic search.