User manual

Universal Remote Control URC 1001
English - 11
 If the most important device functions work
correctly, press the OK button (22) to save the
setting. The message [SUCCESS] will appear
for a few seconds and the device returns to the
previous menu [BRAND SRCH].
 Quit the programming mode by pressing the
EXIT button (23) twice.
Entering Device Codes directly
Power on the device for which you want to
program the remote control. If your device is a
VCR or a CD or DVD player, please also insert a
tape or CD/DVD.
To cancel the following programming at any time,
press EXIT (23) to return without saving any
changes. Press the EXIT button (23) multiple
times until the remote control has returned to
standard mode.
Proceed as follows to enter the device codes
directly (this example refers to programming a TV
set).
Search for the first available code by using the
device type and manufacturer (see the list starting
from page 67).
 Point the remote control to the TV set while
entering the commands.
 Press the source device selection button of the
device you want to program. In this example, it
is the TV button (2). The display shows [TV].
 Press and hold the SET button (21) for at least
3 seconds. The display shows [CODE SETUP].
Then release the SET button (21).
 Press the OK button (22). The display shows
[BRAND SRCH].
 Press
(8) twice. The display shows
[CODE SET].
 Press the OK button (22). The message [TV]
will blink on the display. The current device
code is the 4-digit code below it.
 Press the OK button (22) again. The first digit
of the current device code starts blinking.
 Enter the four digits of the device code that you
have found on the list. To do this, press the
numeric keys (3).