User manual

Universal Remote Control URC 1001
10 - English
 Press the OK button (22). The display shows
[BRAND SRCH].
 Press the OK button (22). The display shows
the first preset manufacturer name, e.g.
[A R SYSTEM]. Underneath the device code of
the displayed manufacturer appears.
 Now enter the first letter of the desired
manufacturer by using the numeric keypad.
The letter assignment is equivalent to the
keypad on a mobile phone.
For instance, press the 5 JKL button (3) if the
device is made by JVC, or press the 7 PQRS
button (3) if it is a Sony-branded device. The
first available manufacturer name will appear
on the display.
 Press the OK button (22) to enable the entered
item. The first available manufacturer name will
appear on the display.
However, you may also enter additional letters.
If you make a mistake, press EXIT (23) to undo
it.
 Press the
or button (8) to scroll through
the alphabetical list of manufacturer names.
Use this method to select the desired
manufacturer name until it shows on the
display.
 Point the remote control to the TV set and
press any button to check if it works properly.
To verify functionality, do not use (8),
OK (22), EXIT (23) or any numeric keys
0…9 (3). At this time, these buttons are
reserved for programming only.
 If the device fails to respond as desired, press
the
button (8) to recall the next available
device code. Then check its operation again.
Repeat the above steps until you gain
successful device control.