User manual

Universal Remote Control URC 1001
English - 9
Programming the Remote Control
Programming Device Codes
To be able to control a device with your universal
remote control, you must first set up the
corresponding device codes. For the PC device
selection, please read the description starting from
page 22.
There are different ways to setup the device
codes.
 The easiest method is to search by
manufacturer.
For a description, see below.
 You can also look for the device code in the list
on page 67 of this User's Manual and program
it manually.
For a description, please read from page 11
 Or use automatic search to locate the suitable
device code. The type of programming takes a
few minutes and is recommended only if your
device is not contained in the list of preset
codes.
For a description, please read from page 12
Programming the Device Code by
Manufacturer Name
Power on the device for which you want to
program the remote control. If your device is a
VCR or a CD or DVD player, please also insert a
tape or CD/DVD.
To cancel the following programming at any time,
press EXIT (23) to return without saving any
changes. Press the EXIT button (23) multiple
times until the remote control has returned to
standard mode.
Proceed as follows to program the device codes
(this example refers to programming a TV set).
 Point the remote control to the TV set while
entering the commands.
 Press the source device selection button of the
device you want to program. In this example, it
is the TV button (2). The display shows [TV].
 Press and hold the SET button (21) for at least
3 seconds. The display shows [CODE SETUP].
Then release the SET button (21).