User manual

Universal Remote Control URC 1001
8 - English
While sending a command by pressing a button,
the display and buttons backlight illumination will
turn off. As soon as you release the button the
backlight illumination will turn on again. This is not
a fault: it has been designed to maximise the
transmission range.
To improve readability, the letters are not printed
onto the numeric keypad of the remote control.
The described button functions are available only
whenever the programmed device supports these
functions.
Inserting the Batteries
Open the battery compartment cover on the back
of the remote control.
Insert the supplied batteries (size AA) into the
remote control. Be sure to respect the polarity
(see also the figure below). The polarity is
indicated with the symbols + and – on the
batteries and in the battery compartment on the
remote control.
Slide the battery compartment cover in the
opposite direction onto the remote control until it
clicks into place.