User`s guide

Configuration of the Scanner to the Host System

The scanner is shipped from the factory programmed to a set of default

conditions noted in the ScanSelect™ Scanner Programming Guide by an

asterisk that appears before the brief definition next to the bar code.

In order for the scanner to communicate with the host system properly, it needs

to be programmed to meet your specific scanning needs. Since each host

system is unique, the scanner must be configured to match the host system

requirements. The scanner can be configured by entering program mode and

scanning the appropriate bar codes that appear in the ScanSelect Scanner

Programming Guide. (When using ScanSet™, refer to the ScanSet

documentation for information on how to configure the scanner.)

1. Connect the scanner to the host system (Refer to the Scanner

Connections to the Host section in this guide).

2. Enter program mode by scanning the ENTER/EXIT program mode bar

code. (The unit will beep three times)

3. Scan the appropriate bar code(s) that appear in the ScanSelect Scanner

Programming Guide. (Reveal only one bar code to the scanner each

time. With your hand, cover the bar code that should not be scanned.)

4. Exit program mode by scanning the ENTER/EXIT program mode bar

code again. (The new options will be saved and the scanner is ready for

normal operation.)