User`s guide

Scanner Connections to the Host

In order for the TECH 10 scanner to maintain compliance with applicable

standards, all circuits connected to the scanner (Example: power supply, host

system, etc.) must meet the requirements for SELV (Safety Extra Low

Voltage) according to EN60950.

To avoid potential problems, do not power up the scanner until the

communication cable is secured to the host.

1. Turn off the host system.

2. Locate the 19-pin female end of the scanner link cable and find the

widest key located above pins L and A. Align this key with the

corresponding key on the scanner box’s Mil spec connector. While

pushing in on the connector, rotate the ring clockwise until it locks into

place with a click.

3. Connect the other end of the communication cable to the host device. (If

the scanner will not receive power from a transformer, skip to Step 6.)

4. If the scanner will receive power from an external power source, check

the AC input requirements of the transformer to make sure the voltage

matches the AC outlet. (A socket-outlet can be installed near the

equipment and can be easily accessible.)

5. Plug the transformer into the AC outlet to supply the power to the

scanner.

6. Power up the host system.

7. Scan a few items to verify that data is being properly transmitted

between the scanner and the host device.