Specifications

16
Scale Protocols
The following bar codes will change scale parameters intended for a Dual Cable
environment. To place the scanner in Dual Cable mode, please refer to
page 25.
If the MS2xx0 is currently in a Dual Cable configuration, temporarily disconnect
the Scale to Host cable prior to configuring the scale.
The MS2xx0 does not need to be in scale service mode.
The Scale Save Data bar code must be scanned last to save the changed
configuration (see page 2).
*NCI = 4 Status Bytes
³ 9 9 6 0 5 2
Set the number of status bytes reported by
the NCI scale protocol to 4 status bytes.
* Factory Default Setting
NCI = 2 Status Bytes
³ 9 9 6 0 5 3
Set the number of status bytes reported by
the NCI scale protocol to 2 status bytes.