Specifications

6
Pole Display Configuration
The following bar code can be used to configure a Single or Dual Cable
MS2xx0.
If the MS2xx0 is currently in a Dual Cable configuration, temporarily disconnect
the Scale to Host cable prior to configuring the scale.
The MS2xx0 does not need to be in scale service mode.
The Scale Save Data bar code must be scanned last to save the changed
configuration (see page 2).
Scale Has No Display
³ 9 9 6 0 0 4
Set the scale to
not require
a remote
display. All weights are expected on a POS
terminal display.
A remote display can not be plugged into
the Scale to Display connector on the
MS2xx0 (see Figure 1).