User`s guide

MS9535 Voyager BT Quick Start Guide
END USER DOCUMENTATION
MS9535 Voyager BT Page -1 Updated: June 2010
Key Barcodes
The following barcodes are the only ones you would normally need to deal with.
To set the scanner back to factory defaults, scan both scans below. An "ET" 3-beep sound should play.
Reset to factory defaults (scan both)
Select the 2nd scan below (CodeGate Inactive in Stand) for scanning in the cradle. Otherwise you will need to
push the button on the top of the scanner each time a barcode is presented.
For in cradle scanning
Enable Range Gate for bulk scanning. Disable (default) otherwise.
Only if you have the MI9535-538-3 (DO NOT have the -5M extended memory)