User`s guide

MS9535 Voyager BT Quick Start Guide
END USER DOCUMENTATION
MS9535 Voyager BT Page -1 Updated: June 2010
entered one per line in your text editor. There should be no special characters, no start character or end
character (like an asterisk) - just the numeric value scanned for each member.
b) If you are scanning for the bulk entry mode -- you DO NOT want to connect your USB connector to your host
device. Without a connection, the scanner/cradle will store up to 2,000 scans in the memory if you enabled the
Range Gate or Inventory Mode. Once you have scanned a set of barcodes, you then put the scanner back in the
cradle, and connect the scanner USB cable back up to the host device.
Ready to Go
Once you have practiced above (several times), you are ready to scan barcodes at your meeting. Enough cannot
be said about practicing
before
the first meeting -- and even having a separate paper check-in system going in
parallel at the first meeting or two.
IMPORTANT - Bulk Scanning Note
With this scanner, if you are bulk scanning barcodes at your meeting (enable Range Gate set), once you connect
up your USB cable to the host device (your desktop or laptop), the scanner will immediately start spewing out the
stored scans. Once the scans are transmitted, they are deleted from the scanner. This means you have a one-
time opportunity to empty the scans into the right place in the DaCdb database. In other words you must be
online and have up, and your cursor in (click-in) the bulk entry form. if you are anywhere else, you will lose your
scan data and will not be able to replay the data. Don't call us -- don't call Honeywell either -- it is a feature of the
scanner.