MS9535 Voyager BT Series - Quick Start Guide BY Mark R.
MS9535 Voyager BT Quick Start Guide END USER DOCUMENTATION Introduction This guide was created to help new users get started quickly and without having to read several hundred pages of technical manuals that came with your scanner. However -- we don't want to discourage you from reading (a lost art in America) all about your device. So, do please read the manual cover to cover -- if you can. What to purchase - or What did I Purchase? There are two versions of the Metrologic MS9535 Voyager BT.
MS9535 Voyager BT Quick Start Guide END USER DOCUMENTATION Note: I found that you could do this step before #1 or #2 above. If you cannot get the blue LED light to stay on -- something is wrong at this point, and it is rather pointless to continue further here. The key thing is to get your computer to recognize the scanner. On a Windows 7 this should look like a Bluetooth keyboard.
MS9535 Voyager BT Quick Start Guide END USER DOCUMENTATION If you are going to scan the barcodes into the system one at a time, then you do not need to set Range Gate or Inventory mode. Also, if you are using the Off-line program, you do not need to set range Gate or inventory mode as that accepts the scans one by one. Question - are you scanning in the cradle? The scanner can either operate in a handheld mode or in the scanner.
MS9535 Voyager BT Quick Start Guide END USER DOCUMENTATION entered one per line in your text editor. There should be no special characters, no start character or end character (like an asterisk) - just the numeric value scanned for each member. b) If you are scanning for the bulk entry mode -- you DO NOT want to connect your USB connector to your host device. Without a connection, the scanner/cradle will store up to 2,000 scans in the memory if you enabled the Range Gate or Inventory Mode.
MS9535 Voyager BT Quick Start Guide END USER DOCUMENTATION Resetting the Unit I'm frustrated -- its not working. OK, before you call support below, try the following steps. 1) Reset the Scanner -- Hold the scanner towards the ceiling (not your eyes) and hold the CodeGate button at the top for 30-seconds. You should hear a beep and the Bluetooth light will start blinking. 2) Reseat all the cables. This includes the power cable, and the USB cable -- at both ends.
MS9535 Voyager BT Quick Start Guide END USER DOCUMENTATION Key Barcodes The following barcodes are the only ones you would normally need to deal with. Reset to factory defaults (scan both) To set the scanner back to factory defaults, scan both scans below. An "ET" 3-beep sound should play. For in cradle scanning Select the 2nd scan below (CodeGate Inactive in Stand) for scanning in the cradle. Otherwise you will need to push the button on the top of the scanner each time a barcode is presented.
MS9535 Voyager BT Quick Start Guide END USER DOCUMENTATION Only if you have the -5M Extended memory MS9535 Voyager BT Page -1 Updated: June 2010
