User`s manual

External Floppy Drive Installation

1. Please make sure the USB ports in the CMOS setup are enabled.

2. Connect FDD USB cable to the USB port of Crossbow.

3. Please complete the installation of the USB driver according to the instruction shown on the

screen.

CD-ROM Installation

1. Please make sure the IDE 2 in the CMOS setup are

enabled.

2. Turn off the power.

3. Plug CD-ROM cable to CD-ROM port.

Note: If the CD-ROM can not be detected by the system,

please refer to troubleshooting.

Cash Drawer Installation

1. Before the cash drawer has been connected to Crossbow, please make sure the driver

voltage and cable pin assignment of the cash drawer is matched to the definition of the cash

drawer port of Crossbow. Please refer to page 52 Cash drawer RJ11 connector

2. Plug cash drawer cable into cash drawer port.

Note: If the cash drawer cannot be detected by the system, please refer to troubleshooting.

Up to two cash drawers may be driven from this port. The driving voltage of solenoid is DC+12V.

I/O port 408h is used for solenoid operation.

To open drawer1, write E0h to this port, wait 200 msec, then write F0h to turn off the drive.

To open drawer2, write D0h to this port, wait 200 msec, then write F0h to turn off the drive.

CMOS Setup

Crossbow systems have adopted either the motherboards NOVA3710DV or NOVA3710SV , both

using AWARD BIOS.

Please refer to the NOVA3710 M/B user's manual chapter 4 for a detailed description of BIOS

CMOS setup.