User`s manual

VFD Customer Display Installation

An optional VFD customer display can be installed on the back of Crossbow. A VFD customer

display cannot be installed at the same time as a second LCD panel or second LCD touch panel.

Rear view with VFD attached

Installing a VFD

1. Turn off system power.

2. Make sure that JP1 and JP2 on secondary I/O board 9000PB270 are set correctly. Please

refer to page 58, Mode1 RJ45 connector used for VFD .

3. Install the VFD to the back of the main

unit with 3 screws.

4. Connect the VFD RJ45 cable in the VFD

port on the I/O panel.

5. Turn on VFD power switch, then turn on system power

Note: If the VFD does not display correctly after an application is loaded, please refer to

troubleshooting.