User`s guide

3 - 6
To establish ReM administrative settings:
1. Change the parameter(s) in the Admin Settings section that you wish to alter:
Parameter Description
Tab Names Allows you to assign user-friendly labels to each of the tabs displayed on
the Find, Update, Configure, and Monitor pages.
Enable Automatic
Refresh
Controls whether new Find results display on other ReM pages automati-
cally.
If this box is checked and you run a new Find operation, the new list of
found devices displays automatically when you access the Update, Config-
ure, Statistics, Monitor, or Licensing pages.
If this box is not checked and you perform a new Find then access another
page, the list of found devices will update automatically unless
there is an
operation in progress on that page or the page displays the results of a pre-
vious operation. In those cases, the Find results will not update on the
page until you click Refresh, which now displays red. Turning Enable
Automatic Refresh off protects operations in progress on a page and pre-
vents the loss of previous operations’ results.
Allow “Find All”
Option
Determines whether the Find All option on the Find page displays (see
page 3-10).
Pull File Name The name of the file that users can upload on the Configure page (see
page 3-15). Type the file name without a path.
File names for scanner models beginning with IS or MS should have an
extension of .mst. All others should use .exm.
Push File Name The name of the file that users can download on the Configure page (see
page 3-15). Click Browse to select a file or type in the file name, including
path. When you save your settings, ReM copies the file to the ...\Tomcat
6.0\Remote MasterMind folder on the web server.
File names for IS and MS scanner models should have an extension of
.mst. All others should use .exm.
Firmware File Name The firmware file to be used on the Update page (see page 3-13). Click
Browse to select a firmware file or type in the firmware file name, including
path. When you save your settings, ReM copies the file to the ...\Tomcat
6.0\Remote MasterMind folder on the web server.
Firmware file names for IS and MS scanner models should have an exten-
sion of .fwz, .hex or .mot. All others should use .bin, .moc or .mocf.
Processor Type For IS and MS model numbers only, the processor in the scanner that the
firmware file should be applied to on the Update page:
MAIN
CO-PROCESSOR-MAIN
CO-PROCESSOR-BOOT