Troubleshooting guide

28
DEFAULT SETTINGS
Many functions of the scanner can be “configured” or enabled/disabled. The
scanner is shipped from the factory configured to a set of default conditions. All
default parameters of the scanner have an asterisk ( * ) marked in the default
column. If an asterisk is not in the default column then the default setting is off or
disabled. Every interface does not support every parameter. A check
mark (

) will appear in the interface column if it supports the parameter listed.
Parameter Default OCIA RS232
Light
Pen
IBM
46xx
KBW USB
Laser
Emulation
Normal Scan Mode
*
      
Continuous Scan Mode
      
Blinky Scan
      
Continuous Blinky Scan
      
Custom (one shot) Scan
      
Manual Activation Mode
      
CodeGate Active
*
      
CodeGate Inactive
      
UPC/EAN
*
      
Code 128
*
      
Code 93
*
      
Codabar
*
      
Interleaved 2 of 5 (ITF)
*
      
MOD 10 check on ITF
      
Code 11
      
Code 39
*
      
Full ASCII Code 39
      