Installation guide

4
BarCode Scanner Interface
Pin assignments for D-sub 9 pin (Barcode scanner side):
Pin No. Function
2 TXD
3 RXD
5 GND
7 CTS
8 RTS
9 +5V
RS232C communication parameters
A barcode scanner with either of the following configurations can be used:
Baud rate Data length Parity Stop bit
PS700 Default Settings 9600 8 bits Non 1
Metrologic MS5100
Eclipse Default Settings
9600 7 bits Space 2
Data format
Bar code number (ASCII code) CR (0D<hex>) LF (0A<hex>)
Note: The cash register is able to receive scanned data from a barcode scanner in the data
format above.
This format is the default setting for the PS700 and Metrologic MS5100 Eclipse.
If you use another type of barcode scanner, please change the transferred data to above
format using your barcode scanner. For programming instructions, refer to the manual of
your barcode scanner.
Graphic Logo Characteristics
Some restrictions apply as to the type of Logo:
• Logo size: Width 288 x Height 216 (pixels).
• If the ratio of black dots printed with respect to white is high, the ECR is not able to print
the graphic image properly due to power consumption limitations.