Operating instructions

Example for bar code scanner Page 7 of 12 Issued: 03/2002
10. Load the project into the MT:
Open the project.
• Call the project transfer.
• The code generator is opened. Press "NO" if you are asked for the bitmaps.
• Confirm the ready message with "OK".
• Set the transfer interface (e.g. COM 2, 57600 baud – same setting as for the MT) and confirm with
"OK".
• Question whether the system should also be loaded: The first time this message is displayed it must
be confirmed with "YES". If the system has already been transferred this question can be answered
with "NO".
11. If still no communication is possible, reboot the complete system by performing a cold start (voltage
OFF/ON).
The green LED on the scanner indicates that it is ready for scanning. You can now hold any available bar code
of your choice in front of the scanning window (CDs, floppy disks, bottles, Tetra Packs, etc). Every time the
scanner has successfully read the bar code a beep tone sounds.