User`s guide
Table Of Contents
- IS4225 ScanGlove® Laser Bar Code Scanner Installation and User’s Guide
- Disclaimer / Trademarks
- Table of Contents
- Introduction
- Scanner and Accessories
- Scanner Installation
- Scanner Configuration to the Host System
- Parts of the Scanner
- Visual Indicators
- Audible Indicators
- Labels
- Maintenance
- Depth of Field
- Object Detection Device
- Specifications
- Default Settings
- Troubleshooting Guide
- Regulatory Compliance
- Patents
- Limited Warranty
- Index
- Customer Support
- Manual Date Code
SCANNER INSTALLATION
1. Turn off power to the host system.
2. Connect the communication cable to the proper port on the host device.
3. Turn on power to the host system.
When the IS4225 first receives power, the red LED will flash, the
green LED will flash, and then the scanner will beep once.
2
See power source caution statement on page 7 of this manual.
To maintain compliance with federal regulations 21 CFR, Part 1040.10,
section (f)(6) the scanner must be plugged into an electrical outlet with a
switch accessible to the user or be powered by a host system containing a
switch that will disable power to the scanner.