User`s guide

13
DEFAULT SETTINGS
Many functions of the scanner can be "configured", that is enabled or disabled.
The scanner is shipped from the factory
configured to a set of default conditions.
All factory default parameters have an asterisk ( * ) in the default column of the
charts on the following pages . If an asterisk is not in the default column then the
setting is off or disabled by default. Every interface does not support every
parameter. If the interface supports a parameter listed in the charts on the
following pages, a check mark () will appear.
Parameter Default RS232
Light
Pen
Keyboard
Wedge
USB
Enter Configuration Mode, After Any Scan
*
   
Enter Configuration Mode, Only on First
Scan
   
Short Range Activation
   
Long Range Activation
*
   
Normal Scan
*
   
Custom Scan
   
DTR Activation

DC2 Activation

Address Based Activation

“NOREAD” message Transmission

Turn on Green LED during “NOREAD”
Transmit
*

Same Symbol Re-scan
*
   
Green LED Identical Symbol
Re-Scan Indicator
   
1 Vs 2 Scan Buffers 1

   
2X Redundancy (MECCA)
   
Double Border Requirement
(Large Intercharacter Space Requirement)
   
Alternate Beeper Tone 1
   
Alternate Beeper Tone 2
*
   
Alternate Beeper Tone 3
   
No Beeper tone
   
Two Second Timeout
