User manual

ScanVue5
®
Mini Kiosk
User Manual
M37574–01T
Industrial Electronic Engineers, Inc.
23-June-2008 RevT Page 60
1
IP addresses (‘XXXXXXXX’) are in hexl notation. Each of the quads in the address becomes a pair of hex digits (e.g., 10.0.0.10 is encoded as 0A00000A).
2
String values start with the count of characters (‘L’) followed by the characters of the string (‘SSSSSSS’). ScanVue5
®
preserves the case of characters in strings even if it is not
meaningful to the network or host. The length field is always 2 digits i.e., 3 must be 03.
3
Numerical values (‘L’ and ‘NNNQ’) are decimal. Numerical values must be followed by a non–digit character. Purely numerical parameters (e.g., Product Info Port) should be followed
by an upper–case alpha character to prevent confusion caused by check–characters and stop codes.
4
If shipped as a hardwired unit it has the default IP address shown. If shipped as an RF wireless unit the default is DHCP.
5
The barcode is shown in the Metrologic user manual
6
There are 2 different screens depending on the type of RF radio card installed.
7
Setting the Host name also sets SMB file–access mode. Setting the File Server IP also sets FTP file–access modes.
8
Not available
9
Not available
Command barcodes must be at least six characters long, including the two–character prefix but excluding the check character and any
start and stop characters. Extra padding characters may be added to guarantee this. Padding characters should be upper case alpha
characters and are ignored. Numerical values may be zero padded (e.g., ‘0001’ instead of ‘1’).
It is highly recommended that barcodes be created in Code 128. The barcodes shown in the table are in Code 128 format. Some
other codes generate numeric check characters which MUST be terminated with an alpha character to prevent ambiguity.
The following single and paired characters should NOT be used in barcodes: A, F, E0, FF, B1, B2, B3