User manual
ScanVue5
®
Mini Kiosk
User Manual
M37574–01T
Industrial Electronic Engineers, Inc.
23-June-2008 Rev T Page 57
need a hard copy of pages v[p6] (Recall Defaults), A4[p11] (Code 39), and E9[p76]
(NCR Prefix ID) of the Configuration Guide.
Create barcode labels in Code128 containing the network information as shown in Table
2 on pages 58 & 59. A program such as ‘Avery Label Pro’ or ‘B–Coder Lite’ from
Taltech can create these for you. ‘B–Coder Pro’ can also print the barcodes required to
configure the scanner.
Follow the step–by–step procedure outlined in the following pages to configure
ScanVue5
®
using barcodes:
1. Power up the ScanVue5
®
unit. Wait until it finishes booting, the 2 blue status
screens have been displayed and the IEE logo clears. If you have an RF unit, a red
connection diagnostic screen may appear if the unit doesn’t connect to your network.
Either way, you are ready to reconfigure.
2. Scan the following label.
Recall Defaults
Each label will generate a single beep when scanned properly, then a double beep
to acknowledge the operation is complete.
3. Scan the specific labels (listed in Table 1) required to change the configuration to
your network’s parameters. Each setup label will beep once when scanned
correctly. ScanVue5
®
will display the raw code, then the setup name and entered
value. Frequently used bar codes are provided as a .PDF file on the CD–ROM and
may be printed and used directly from the page.
4. When all the setup labels have been scanned in and visually verified, scan the Save
Configuration label. This causes the complete configuration setup to be written to
ScanVue5
®
non–volatile memory and reboot so the changes will take effect.
5. At this point, use the MetroSelect™ Configuration Guide to scan in the configuration
for the barcode scanner. Recommended settings are shown on page 31. The most
common configuration requires scanning the Enable NCR Prefix ID code. This
prevents any legitimate UPC barcode from being read as a configuration barcode.
6. If you need to enter WEP keys by barcode, refer to pages 22 and 23 for specific
instruction on how to do this.
7. This completes the network configuration for ScanVue5
®
. If your network servers
have already been set up, ScanVue5
®
will start communication with the network
normally.