User manual
ScanVue5
®
Mini Kiosk
User Manual
M37574–01T
Industrial Electronic Engineers, Inc.
23-June-2008 Rev T Page 43
Port3Input Defines whether Scanvue sends a character at a time or a complete line
to server. Default value=CHARACTER
Value Function
LINE Buffers all characters until CR or LF received then
sends entire string to host. Typically used with MSR
CHARACTER Sends each character as received to host. Typically
used with NCR K590 printer
BypassNCRPrefix
Instructs Scanvue to accept NCR prefixed bar codes for programming.
Default value = TRUE. NCR prefix mode does not have to be turned off
to be able to program the unit with barcodes.
ExtCharacterSet
Applicable only to ScanVue420 VF (Century) display models. Selects a
character set (language) for display. The default character set contains
‘European’ in 64 positions AO-DF. The extended language character
sets are shown in Appendix D.
Character Set Value
ASCII+European EUROPEAN (default)
ASCII+Katakana KATAKANA
ASCII+Cyrillic CYRILLIC
ASCII+Hebrew HEBREW
PointerHScale Sets the touchscreen horizontal resolution to any integer value between
1 and 16
PointerVScale Sets the touchscreen vertical resolution to any integer value between 1
and 12
KeepAliveTime When set to 0, the unit will operate in its normal mode: that is, it will
close the socket on port 1283 when the transaction is complete. If any
non-zero value is entered, the socket is kept open by “keep alives” sent
at the frequency based on the value set in seconds. Note:
KeepAliveTime must be reset to 0 to connect to UnitConfig
Command modes
Commit Set TRUE, causes the mode settings received to be written in internal
flash memory and become the defaults for future operation. FALSE
indicates that some settings have been changed but not recorded.
Invalidate Sets all mode values to factory defaults and restarts the unit.
Restart Set TRUE, causes the unit to restart. This must be done after a commit
to use the new settings.
TextReset Set TRUE, causes the setting for displayed text to be immediately
enforced. FALSE indicates that some settings have changed. For the