User manual

ScanVue5
®
Mini Kiosk
User Manual
M37574–01T
Industrial Electronic Engineers, Inc.
23-June-2008 Rev T Page 41
Miscellaneous configuration
DateTime The current date and time in the format YYYYMMDDhhmmss. This will
be correct only if the host has set this value, or if NTPHost is set and
ScanVue5
®
is able to obtain the correct time from the NTP server.
EventEnd An 8 character string of hex digits (32 bit mask) which enables ending
events for a specific device as defined in the table below.
EventStart An 8 character string of hex digits (32 bit mask) which enables starting
events for a specific device as defined in the table below.
Mode Value (mask setting)
Disable mask 00000000
h
Pushbutton 0 (leftmost) 00000001
h
Pushbutton 1 (2
nd
from left) 00000002
h
Pushbutton 2 (3
rd
from left) 00000004
h
Pushbutton 3 (rightmost) 00000008
h
Touch panel pressed 00000010
h
Key pressed 00000020
h
Start and end masks are both present in a transmitted packet but one is
always disabled. An input device using both start and stop events will
generate two complete packets, one for start and one for stop. For
most applications the end mask is not required and should be disabled.
Examples and a full explanation of Event mask usage is in the Using
Input Devices section on p.42.
WallPaperEvent An 8 character string of hex digits representing a bit map which enable
event messages (e.g., button pushes) to be sent only during the time
wallpaper is displayed (usually after an item is scanned)
Button
Position
Left 2
nd
from Left 3
rd
from left Right
Label Event0 Event1 Event2 Event3
Value(h) 00000001 00000002 00000004 00000008
The default value 00000000(h) allows all 4 events to operate at all times
and 0000000F(h) only when wallpaper is active.
User1 A string up to 255 characters long that can be set and read by the
application.
RegisterINI ScanVue5
®
will register itself with the ProductInfo host after
successfully reading a new INI file.
RegisterStart ScanVue5
®
will register with the ProductInfo host upon startup.
DisplaySetup Display the first information screen at startup.
DisplaySetup2 Display the second information screen at startup
DisplayAll Display passwords on the information screens
NoBarCodes Disable configuration by barcode mode