User manual

ScanVue5
®
Mini Kiosk
User Manual
M37574–01T
Industrial Electronic Engineers, Inc.
23-June-2008 Rev T Page 30
4. Select WEPEncryption mode and set its value to one of the 3 choices shown in the
table above. If WEP if not being used, leave its default setting of NONE.
5. Select WEPKey1 through WEPKey4 and set all 4 key values.
6. Using WEPKeyIndex set the key value you are using.
7. Commit the changes and reboot the Scanvue unit. New WEP settings will take effect
when the unit has finished rebooting.
8. Enable WEP on the access point–provided the WEP encryption mode and WEP key
selected on Scanvue5 matches the access point settings, Scanvue5 will associate
(connect) seamlessly.
Loading WEP Keys by Barcode
1. The unit does not have to be connected to a computer to load WEP keys by barcode.
2. Preferred format is Code 128 and hex digits A-F should always be upper case
3. Set the WEP encryption mode being used.
WEP encryption mode Function Barcode
NONE WEP encryption off WE4NONE
OPEN40 Open System 40–bit encryption WE6OPEN40
OPEN128 Open System 128–bit encryption WE7OPEN128
4. Set the WEPkey index which selects which one of the 4 possible WEPkeys will be
used. The default WEPkey is WEPkey1—if you intend to use only this one key then
only the WEPkey1 value needs to be loaded.
WEPkey Index # Barcode
WEPkey1 (default) AW0001
WEPkey2 AW0002
WEPkey3 AW0003
WEPkey4 AW0004
5. Set the WEPkey value according to the encryption mode selected
WEPkey value Barcode 40 bit key
(10 hex digits)
Barcode 128 bit key
(26 hex digits)
WEPkey1 WK1h
1
…h
10
WK1h
1
…h
26
WEPkey2 WK2h
1
…h
10
WK2h
1
…h
26
WEPkey3 WK3h
1
…h
10
WK3h
1
…h
26
WEPkey4 WK4h
1
…h
10
WK4h
1
…h
26
6. Scan “Save Configuration”—the settings will be saved and the unit will reboot with
the new WEP keys installed