User manual

ScanVue5
®
Mini Kiosk
User Manual
M37574–01T
Industrial Electronic Engineers, Inc.
23-June-2008 Rev T Page 7
Wall Mounted
The wall mount bracket is provided as a standard item shipped with the unit (Appendix F
for actual dimensions). The wall bracket can be mounted on any type of flat vertical
surface using the 6 mounting bosses with holes. The bracket can also be mounted by a
special double-sided tape to a glass column or wall. Mounting hardware is not provided
as the material used in the vertical wall can vary depending on the location chosen and
either wood screws or toggle bolts or equivalent are recommended. Do not use wood
screws or sheet metal screws in drywall—they will not hold the weight of the unit.
Note: contact factory for recommendation of double sided tape—do not use the kind you might find
in the local drug store or hardware store.
The wall mount bracket is removed from the rear of the unit, sliding it up and off of the 4
vertical tongues, and mounted to the wall, column or endcap. A hole is provided in the
bracket for bringing the power and/or network connection through from the wall or
column.
Locking screws (x2)
Fig 1—Wall Mount Bracket
The ScanVue5 unit is pushed close to the wall about 1” above the bracket tongues.
Push it downward until the 4 tongues mate securely with their counterpart slots in the
rear of the housing. Tighten the 2 locking screws through the slots in the housing until
snug—this will prevent anybody from removing the unit from its mount.