User manual

ScanVue5® Mini Kiosk
User Manual
M37574–01T
Industrial Electronic Engineers, Inc.
23-June-2008 RevT Page 98
Connect Error
A Connect error is the most likely type to occur. The explanations given may not be the
only possible reason for the message.
Connect Fail A general failure to connect to the host. If the host can
ping the unit, getting this error should not be possible.
Connect Timeout The initial connection was made but the host has not
responded to further communication in timely manner.
Refused The host is there and the unit can connect to it. The host
may not have an appropriate server running, or security
may otherwise refuse to allow the connection.
Logon The user name and/or password are incorrect.
Protocol Fail For Windows networking, the unit and the host could not
find a mutually acceptable protocol level.
Share Unavailable The directory requested does not exist, or is not shared, or
protections prevent the unit from connecting to it.
Host Resolution The specified host name cannot be resolved to an IP
address. This can happen if the host name is incorrect or
if the host is on another subnet and there is no WINS
server available or the WINS server IP has not been set.
Transfer This may be a transient error that will not re–occur if you
power cycle the unit and try again. Normally you should
never see this message, as it indicates a failure of software
and/or hardware on the host, the network, or on the unit.
SMB Connect Refused This can occur in the following the following cases:
1. The share POS directory is not accessable; either
because the share does not exist, or user permissions are
not set to allow access.
2. The scanvue.ini file may not exist in the share.
3. The share may exist but access may be denied because
“Guest” account is disabled, or the account identified to
access this share may not be applied to the permissions