- METROLOGIC INSTRUMENTS Scanner Installation and User Guide Eclipse MS5100

5
KEYBOARD WEDG E SCANNER INSTALLATION
1. Turn off the host system.
2. Connect the 10-pin RJ45 plug of the Po werLink cable into the jack on the
MS5145.
3. Disconnect the keyboard from the host system.
4. Connect the L-shaped plug of the po wer supply into the power jack on the
PowerLink cable (refer to the manufacturer’s recommendation and Note on
page 6).
5. Make sure the AC input requirements of the power supply match the AC
outlet. Connect the power supply into an AC outlet (see caution statement
on page 6**).
6. The PowerLink “Y” cable is terminated with a 5-pin DIN female con nector o n
one end, and a 6-pin mini DIN male on t