- METROLOGIC INSTRUMENTS Scanner Installation and User Guide Eclipse MS5100

QUICK START

1. Connect the 10-pin RJ45 plug into the j ack on the Eclipse MS5145. You

will hear a ‘click’ when the connectio n is made.

2. Connect the L-shaped plug of the po wer supply into the power jack on the

PowerLink cable.

3. Connect the power supply into an AC o utlet. Make sur e the AC input

requirements of the power supply match the AC outlet.

(See caution statement below)

4. When the MS5145 is ready to scan, the green LED will turn on, the red LED

will flash and the scanner will beep once.

5. The MS5145‘s operation is automatic. The laser puls es on and off. The

green LED remains on during n orma l puls e operation and it blinks during

power save mode.

Operational Test

6. Place a bar code in front of the scanning window. While a iming at the bar

code with the blinking laser bea m, press the Cod eGate button, scanner will

beep once and flash the red LED if the b ar code was successfully decoded.

7. The scanner is shipped from the factory programmed with default settings.

To configure the MS5145 scanner to meet the host s ystem’s specific ne eds,

refer to the Programming Guide or custom configurati on guide for

instructions on how to change the scanners def ault settings.

Caution:

To maintain compliance with federal regulations 21 CFR, Part 1040.10, section (f)(6) the scanner

must be plugged into an electrical outlet with a switch accessible to the user or be powered by a host

system containing a switch that will disable power to the scanner.