- METROLOGIC INSTRUMENTS Scanner Installation and User Guide Eclipse MS5100

AUDIBLE INDICATORS

When the MS5145 scanner is operatio nal, it provides audible feedback. T hese

sounds indicate the status of the scanner. Eight settings are availa ble for the

tone of the beep (normal, 6 alternate tones and n o tone). T o change the tone,

refer to the Configuration Guide.

One Beep – on power up

The green LED will turn on, then the red LED wil l flash and the

scanner will beep once. T he red LED will remain on for the

duration of the beep. The scanner is no w ready to scan.

One Beep – during operation

When the scanner successfully r eads a bar code, the red LED

will flash and the scanner will beep once (if programmed to do

so). If the scanner does not beep once and the red l ight does

not flash, then the bar code has not been successfull y read.

Three Beeps – during operation

When entering the program mode, the red LED will flash while

the scanner simultaneous l y beeps three times. The red LED

will continue to flash until the unit exits program mode. Upo n

exiting program mode, the scanner will beep three times and

the red LED will stop flashing.

When configured for communication time out, 3 bee ps during

operation will indicate that a communic ation timeout has

occurred.

Three Beeps – on power up

This is a failure indicator. Refer to the Failure Modes section

of this guide on page 11.

Razzberry Tone

This is a failure indicator or an invalid cod e read during

program mode. Refer to the Failure Modes section of this

guide on page 12.