- METROLOGIC INSTRUMENTS Scanner Installation and User Guide Eclipse MS5100

KEYBOARD WEDG E INSTALLATION (CONTINUED)

Manufacturer’s Recommendation

If the keyboard port of the host system cannot supply enough current, the use of

an external power supply with the MS5145 Keybo ard W ed ge wil l be necessary.

Powering the MS5145 directly from the computer keybo ard connector could

interfere with the operation of the scanner or the c omputer. Not all computers

supply the same current through the keybo ard port, so a scanner may work on

one computer and not another (see caution statement on page 5).

Caution:

To maintain compliance with applicable standards, all circuits connected to the scanner must meet

the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.

*To maintain compliance with standard CSA C22.2 No. 60950/UL 60950 and norm EN 60950, the

power source should meet applicable performance requirements for a limited power source.

**To maintain compliance with federal regulations 21 CFR, Part 1040.10, section (f)(6) the scanner

must be plugged into an electrical outlet with a switch accessible to the user or be powered by a host

system containing a switch that will disable power to the scanner

Note: The center of the L-Shaped plug of the power supply is negative (“-“).