Single-Line Laser Scan Engine Integration Guide
Table Of Contents
- IS4813, IS4815, IS4823 and IS4825
- Copyright/Trademarks
- Table Of Contents
- Introduction
- Assembly
- Mounting Specifications
- IS4813 and IS4815 Scan Engine Dimensions
- IS4823 and IS4825 Bracketed (-1 and -2) Dimensions
- IS4823 and IS4825 (-0) Decode Printed Circuit Board Dimensions
- Exit Beam Specifications
- Enclosure Specifications
- Electrostatic Discharge (ESD) Cautions
- Grounding
- Power Supply
- Power Sequencing
- Flex Cables
- Thermal Considerations
- Printed Circuit Board (PCB) Component Clearance
- Magnetic Sensitivity
- Airborne Contaminants and Foreign Materials
- Beam Clearance
- Output Window Properties
- Output Window Coatings
- Output Window Angle
- Minimum Allowable Window Position RequiredTo Avoid Detrimental Internal Reflective Beam Interference at Positive Exit Beam Angle Tolerance
- Minimum Allowable Window Position Required To Avoid Detrimental Internal Reflective Beam Interference at Negative Exit Beam Angle Tolerance
- Scan Engine Field Of View And Depth Of Field
- Descriptions Of IS4823 AND IS4825 Operating Modes
- Serial Configuration Mode
- General Design Specifications
- Detailed Electrical Specifications
- Scan Engine Terminations
- Decode Printed Circuit Board Terminations
- Flex Cable Specifications And Installation Guidelines
- Timing Diagrams
- Bar Code Element Time Calculation
- Regulatory Compliance
- Limited Warranty
- Patents
- Index
- Contact Information
- MANUAL DATE CODE

34
United States
Laser Safety
To assist with the FDA filing requirements (refer to Regulatory Requirements), Metrologic has registered the
scan engine with the FDA as a component. Customers can contact CDRH at the following address:
Food and Drug Administration
Center for Devices and Radiological Health
Light Products Branch (HFX-312)
Office of Compliance
2098 Gaither Road
Rockville, MD 20850
Tel: 301-594-4654
www.fda.gov/cdrh
Requirements for laser products are described in CFR (Code of Federal Regulation) Title 21, part 1040.10 &
1040.11 from the Government Printing Office. Copies can be ordered by calling 202-512-1800, ordering on
line from www.access.gpo.gov or writing to:
Superintendent of Documents
PO Box 371954
Pittsburgh, PA 15250-7954
Note: State and local governments may regulate the use products containing lasers. The manufacturer
should consult the applicable government regulations for more information.
Copies of Product Reporting Guides, other guides, and related documents are available as PDF documents
from the CDRH website at: www.fda.gov/cdrh/comp/eprc.html
. Additional resources include the Division of
Small Manufacturers, International and Consumer Assistance (DSMICA) in Rockville, Maryland at
1-800-638-2041.
EMC
Certain combinations of scan engines and associated electronics may require testing to insure compliance with
the following Federal Communications Commission regulation: 47 CFR Part 15
Note: When using the scan engine with RF equipment, modems, etc. may require examination(s) to the
standard(s) for the specific equipment combination. It is the manufacturers’ responsibility to comply
with the applicable federal regulation(s).
The IS4800 series laser scan engine is designed to meet EN55022 Radiated Class B emission limits.
The engine was installed in a representative system and tested for compliance.