Single-Line Laser Scan Engine Integration Guide
Table Of Contents
- IS4813, IS4815, IS4823 and IS4825
- Copyright/Trademarks
- Table Of Contents
- Introduction
- Assembly
- Mounting Specifications
- IS4813 and IS4815 Scan Engine Dimensions
- IS4823 and IS4825 Bracketed (-1 and -2) Dimensions
- IS4823 and IS4825 (-0) Decode Printed Circuit Board Dimensions
- Exit Beam Specifications
- Enclosure Specifications
- Electrostatic Discharge (ESD) Cautions
- Grounding
- Power Supply
- Power Sequencing
- Flex Cables
- Thermal Considerations
- Printed Circuit Board (PCB) Component Clearance
- Magnetic Sensitivity
- Airborne Contaminants and Foreign Materials
- Beam Clearance
- Output Window Properties
- Output Window Coatings
- Output Window Angle
- Minimum Allowable Window Position RequiredTo Avoid Detrimental Internal Reflective Beam Interference at Positive Exit Beam Angle Tolerance
- Minimum Allowable Window Position Required To Avoid Detrimental Internal Reflective Beam Interference at Negative Exit Beam Angle Tolerance
- Scan Engine Field Of View And Depth Of Field
- Descriptions Of IS4823 AND IS4825 Operating Modes
- Serial Configuration Mode
- General Design Specifications
- Detailed Electrical Specifications
- Scan Engine Terminations
- Decode Printed Circuit Board Terminations
- Flex Cable Specifications And Installation Guidelines
- Timing Diagrams
- Bar Code Element Time Calculation
- Regulatory Compliance
- Limited Warranty
- Patents
- Index
- Contact Information
- MANUAL DATE CODE
17
Descriptions of IS4823 and IS4825 Operating Modes
Activation Modes
The following activation modes initiate the engine’s laser and motor drive circuitry for bar code scanning.
Activate Scanning with the External Trigger (Default).
An external I/O pin is used to enable the scanning cycle. A High-to-Low transition on the I/O signal is used to
activate scanning. The signal must be deactivated (HIGH) and re-activated for subsequent scanning cycles.
The scanning cycle is terminated based on the default period of time (2 seconds), a variable period of time,
when the I/O signal is deactivated (Low-to-High), or when a bar code is scanned and transmitted.
Activate Scanning on Receipt of the <DC2> Character
A received <DC2> character initiates the scanning cycle. The scanning cycle is terminated based on the
default period of time (2 seconds), variable laser timeout selected, or when a bar code is scanned and
transmitted.
Activate/Deactivate Scanning Using D/E
A received ‘E’ character initiates the scanning cycle. The scanning cycle is terminated based on the default
period of time (2 seconds), variable laser timeout selected, or receipt of a ‘D’ or when a bar code is scanned
and transmitted.
Activate Scanning with Address
A configurable address character is used to initiate scanning. The scanning cycle is terminated based on the
default period of time (2 seconds), variable laser timeout selected, or when a bar code is scanned and
transmitted.
Common Activation Mode Features
The following configurable activation mode features are available for the IS4823 and IS4825.
Variable Laser-On Timeout (1-second Increments)
A configurable time increment selected as the scanning laser–on time.
Allow Full Laser-On Cycle
The laser stays on for a full cycle even when a bar code is scanned and transmitted.
Blinky Mode
The scanner will blink for 60 cycles (approximately 30 seconds) once the scanning cycle is activated.