Barcode Reader User Manual

IS1000 – Configuration Guide
iii
TABLE OF CONTENTS
1. INTRODUCTION............................................................................................................. 1
1.1. Default Configuration (factory setting)..............................................................3
2. COMMUNICATION MODES........................................................................................... 5
2.1. RS232.................................................................................................................... 6
2.1.1. Baud Rate..................................................................................................6
2.1.2. Data Bits ....................................................................................................7
2.1.3. Parity.......................................................................................................... 7
2.1.4. Stop Bits ....................................................................................................7
2.1.5. End of Message Character ........................................................................ 8
2.1.6. Time-Out Between Characters ..................................................................9
2.1.7. ACK/NAK Protocol...................................................................................10
2.1.8. XON/XOFF Protocol ................................................................................ 10
2.1.9. RTS/CTS Protocol ................................................................................... 10
2.1.10. PC-Term Mode ........................................................................................ 11
2.2. Keyboard-Wedge ............................................................................................... 12
2.2.1. End of Message Character ...................................................................... 14
2.2.2. Upper / Lower Case Options ................................................................... 14
2.2.3. Types of Numeric Characters .................................................................. 15
2.2.4. Time-Out Between Characters ................................................................15
2.2.5. "WYSE" Time-Out....................................................................................16
2.3. P.O.S. (Point Of Sale) Systems......................................................................... 17
2.4. Wand Emulation................................................................................................. 18
2.4.1. Transmission Speed ................................................................................ 18
2.4.2. Bar/Space Polarity ................................................................................... 19
2.4.3. Idle State.................................................................................................. 19
2.5. Laser Emulation................................................................................................. 20
3. SYMBOLOGIES ...........................................................................................................21
3.1. Symbology Selection ........................................................................................22
3.2. Code 39............................................................................................................... 24
3.2.1. Standard/Full ASCII ................................................................................. 24
3.2.2. Full ASCII Extended ................................................................................ 24
3.2.3. Multiread .................................................................................................. 25
3.2.4. Modulo 43 Check Character .................................................................... 25
3.2.5. Pharmacode or Pharma 32/39................................................................. 26
3.2.6. CIP Code 39 ............................................................................................ 26
3.2.7. Start/Stop.................................................................................................27
3.2.8. Modulo 43 Algorithm................................................................................27
3.3. Interleaved 2/5.................................................................................................... 28
3.3.1. Fixed Length(s) Authorized and Set Upon First Reading(s) .................... 28
3.3.2. Fixed Length(s) Authorized and Set Using the Numeric Pad .................. 29
3.3.3. Variable Lengths Authorized.................................................................... 30
3.4. UPC/EAN............................................................................................................. 31