Instruction Manual

6 Devices

IC Net 2.2

The Program tab contains the two following subpages:

Program Main time program with all program

steps.

Remote configuration Possibility for creation of user-defined

remote commands.

Program

On the Program subpage, program steps including time, program

instruction and parameter can be entered.

First column Time at which program instruction is ap-

plied.

Entry range: 0.0 ... 999.9 min

If no time is entered, the program instruc-

tion is applied together with the last instruc-

tion with time entry.

Second column Program instruction (see below).

In addition to these predefined instructions,

user-defined remote commands can be en-

tered if activated on the

Remote configura-

tion

tab.

Third column Parameter for program instruction (see be-

low).

ENABLED Enable program start (a disabled program

is not started).

Will be executed by Selection if the time program will be exe-

cuted by the

PC or the 732 unit.

<Add> Add new program instruction.

<Delete> Delete selected program instruction.

<Verify> Test the time program (error messages are

displayed if program is wrong).