Owner's manual

6.11 766 IC Sample Processor

IC Net 2.0

Num Row number (read-only).

Task Program instruction (see below).

Parameter Parameter for program instruction (see

below).

Enabled Enable program start (a disabled program

is not started).

<Add> Add new program instruction.

<Delete> Delete selected program instruction.

List of program instructions

The following program instructions can be added to the time pro-

gram on the Program tab:

Instruction Parameter entry Meaning

Move sample, sample+1,

spec.#, 1...n

Move rack to place the specified

vessel at the needle.

Lift shift, work, rinse,

special,

0, 1...125 mm

Raise or lower the lift to the specified

position.

Pump on, off, 1...999 s Switch on/off peristaltic pump at

the tower.

Scan "scan command" Scan remote interface until the

specified signal is received. In ad-

dition to the normal scan com-

mands (details see 766 Instruc-

tion for Use) special commands

defined on the Configuration tab

can be used.