Owner's manual

6 Devices

IC Net 2.0

List of program instructions

The following program instructions can be added to the time pro-

gram on the Program subpage:

Instruction Parameter entry Meaning

Remote 0, 1, * Set remote output lines 1...8 to

the desired values. For entry of

the first value, enter 1, 0 or *. For

entry of the other values, move

the cursor in front of the value to

be changed and enter 1, 0 or *.

Flag reset, end Set program flag. The end flag

can be used to end a program,

especially if the program time

should be longer than the chro-

matogram duration. Additional

steps after this flag are not al-

lowed. The reset flag is used to

reset the parameters to the sys-

tem startup values.

Range 100, 200, 5000 µµS/cm

1, 2, 5, 10 mS/cm

Set measuring range to the se-

lected value.

FS 0.05 µµS/cm ...

10 mS/cm

Set full scale range to the se-

lected value (depends on Range

setting).

Zero on, off Switch on or off the auto-zero

function.

Polarity +, – Reset the polarity of the output

signal.

Mark Trigger marking signal.

ValveA fill, inject Switch injection valve A to "inject"

or "fill" position.

ValveB fill, inject Switch injection valve B to "inject"

or "fill" position.

Suppressor Switch suppressor module to the

next position.

PumpRS on, off Switch on or off the high-pressure

pump connected to the 732 IC

Detector.

Flow 0.01 ... 5 mL/min Set flow rate of the high-pressure

pump to the desired value.