Owner's manual

5.2 762 IC Interface

IC Net 2.0

Event command (2

column)

Setting the event output lines 1…7.

Selection:

0 (line off, inactive, open)

1 (line on, active, 0 V)

p (pulse, pulse length 150 ms)

* (leave line in current status)

For entry of the first value, enter 1, 0, p or *.

For entry of the other values, move the cur-

sor in front of the value to be changed and

enter 1, 0, p or *.

<Add> Add new remote command.

<Delete> Delete selected remote command.

<Activate> Activate the defined remote commands for

insertion into the time program.

Events setup

The Events setup tab of the 762 System [#] window contains the

startup values for the seven event output lines of system 1 or

system 2 of the 762 IC Interface. These startup values are sent

each time the system is connected or a determination is started.

Each event output line can be set to the following values:

0 Line off, inactive (open)

1 Line on, active (0 V)

For technical information see 762 Instructions for Use.