User guide

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Installation
920 Absorber Module
￭￭￭￭￭￭￭￭
69
On the … of
the absorber
tube
Install this accessory
side ￭ Inlet valve holder (6.2766.010) consisting of a holder and a nut
with inlet valve (6.2824.170)
￭ PTFE capillary 1/8 in. / 1/16 in. ID / 1.5 m (6.1803.130) (21-8)
bottom ￭ Pressure screw (6.2744.010)
￭ The loose end of the PTFE capillary 0.75 mm ID / 3 m
(6.1803.160), connected to port 8 of the 10-port valve (21-5).
Connecting the capillaries
6.1803.160
60 cm
6.2744.010
6.2766.010
6.2824.170
6.1803.130
6.2744.170
1
Installing the check valve
￭ Insert the inlet valve into the holder for the inlet valve.
￭ Tighten the nut on the holder by hand.
￭ Screw the check valve in place on the frit of the holder.
2
Mounting the input capillary
Screw the thicker PTFE capillary (21-8) in place on the check valve
using a pressure screw (6.2744.170).
3
Mounting the outlet capillary
Tighten the loose end of the capillary (21-5) (connected to port 8 of
the 10-port valve) to the bottom of the absorber tube holder using a
pressure screw (6.2744.010).