User guide

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭

3 Installation

815 Robotic USB Sample Processor XL

￭￭￭￭￭￭￭￭

3.13.2 Connecting a stirrer or titration stand

You can use a magnetic stirrer 801 Stirrer or 803 Ti Stand (stirring "from

below") or the 804 Ti Stand with a rod stirrer 802 Stirrer (stirring "from

above").

Connect a stirrer or a titration stand as follows:

Connect a stirrer or titration stand

￭ Exit the control software.

￭ Connect the connection cable of the magnetic stirrer or of the

titration stand to one of the sockets marked with MSB on the

rear of the control instrument.

￭ If desired, connect the rod stirrer to the stirrer socket (with stirrer

symbol) of the titration stand.

￭ Start the control software.

USB 1

Contr.

MSB 2

MSB 3

Figure 27 Connecting MSB stirrer

Figure 28 Rod stirrer and titration stand