Owner's manual

Inhaltsverzeichnis

797 VA Computrace / Hardware-Manual 8.797.8001EN

III

List of figures

Fig. 1: Front of the 797 VA Computrace Stand .....................................2

Fig. 2: Rear of the 797 VA Computrace Stand ......................................3

Fig. 3: Right side view of the 797 VA Computrace Stand (fully

equipped)..................................................................................

Fig. 4: Left side view of the 797 VA Computrace Stand (fully

equipped)..................................................................................

Fig. 5: Connection to PC ....................................................................14

Fig. 6: Measuring head arm................................................................15

Fig. 7: Scheme showing the inert gas connections at the 797 VA

Computrace Stand...................................................................

Fig. 8: Multi-Mode-Electrode..............................................................21

Fig. 9: Adding the mercury................................................................. 22

Fig. 10: Setting up the filling station.....................................................26

Fig. 11: Filling the capillary...................................................................26

Fig. 12: Measuring head arm with rotating disk electrode (RDE) ...........35

Fig. 13: Construction of the reference electrode...................................36

Fig. 14: Construction of the auxiliary electrode..................................... 39

Fig. 15: Electrical connection of the 863 Compact Autosampler ...........47

Fig. 16: Tubing connections for operation of the 863 Compact

Autosampler............................................................................

Fig. 17: Installation of accessories for rinsing and siphoning off............ 48

Fig. 18: Adjusting the pipetting needle.................................................49

Fig. 19: Complete system for automation with the 838 Advanced

Sample Processor ....................................................................

Fig. 20: Tubing connections for the rinsing equipment with the 838

Advanced Sample Processor ....................................................

Fig. 21: Electrical connection for a combined system with the 838

Advanced Sample Processor ....................................................

Fig. 22: Tubing connections for Suppressor determination with the

838 Advanced Sample Processor (and DT) with a combined

system.....................................................................................

Fig. 23: Tubing connections for Brightener determination with the

838 Advanced Sample Processor with a combined system .......

Fig. 24: Measuring head for a combined system with the 838

Advanced Sample Processor ....................................................

Fig. 25: Electrical connection for Suppressor determination with the

838 Advanced Sample Processor .............................................