Instruction Manual

4.3 Exploratory curves
797 VA Computrace – Software
75
If a signal file is loaded or measured, the axes have the following
orientation:
x axis The previously loaded or measured signal is dis-
played from the left to the right. For cyclic sweeps,
the forward sweep is displayed from the left to
the right.
y axis The y axis is displayed with positive values at the
top.
Load signal curves
The signal curves are loaded into the EXPLORATORY CURVES win-
dow by loading the signal files (
*.sig) in the EXPLORATORY SPECI-
FICATION
window.
EXPLORATORY SPECIFICATION / File / Load signal
Load one or several (Ctrl + Click) existing signal
file(s) with its measurement parameters. Normally,
signal files are stored in the Data folder.
Select signal curves
One of the signal curves loaded into the EXPLORATORY CURVES
window is always shown with
Selected signal properties which can
be set different from all other curves loaded (see
Curve properties,
section 3.5). The selection of this signal file is done in the Signal
field of the EXPLORATORY SPECIFICATION window. An asterisk *
in this field marks the signal file whose parameters are loaded in
the EXPLORATORY SPECIFICATION window. Only this signal file
can be stored.