Instruction Manual

8 How to ...?
797 VA Computrace – Software
206
Note: If you switch off the instruments, switch off the 731 Relay
Box first.
8.2 User rights
Define a new user
1. Open the USER RIGHTS window by clicking on MAIN WINDOW
/ Us
er / User rights.
2. Click the button to open the ADD NEW USER
window.
3. Enter the
Name and Password of the new user.
4. Close the ADD NEW USER window by clicking <OK>.
5. Select the new user in the list of all users and set his user rights
(see
User rights, section 2.6).
6. Close the USER RIGHTS window by clicking <OK>.
Change user rights
1. Open the USER RIGHTS window by clicking on MAIN WINDOW
/ Us
er / User rights.
2. In the User rights tab, select the desired user in the list of all
users and change his user rights (see User rights, section 2.6).
3. In the User directories tab you can define where data and
methods are saved for each specific user.
4. Close the USER RIGHTS window by clicking <OK>.
8.3 Signals in exploratory mode
Load a signal curve
1. Click on
or MAIN WINDOW / Mode / Exploratory.
2. Click on or EXPLORATORY SPECIFICATION / File / Load
signal
.
3. Select one or several (Ctrl + Click) signal files *.sig in the OPEN
window and click <OK>.
Note: As soon as a signal curve is measured or loaded, the volt-
ammetric parameter get read only. Should the parameters be
changed before measuring a new signal curve, the button
needs to be clicked.