Instruction Manual

ManualsBrandsMetrohm ManualsSoftware797 VA Computrace

1.3 Installation

797 VA Computrace – Software

9. Start the 797 VA Computrace Software 1.3.x.

10. Set hardware settings for the 863 Compact VA Autosam-

pler.

11. Check the checkbox for

Relay box / Pump Station on the Auto-

mation

tab of the GENERAL SETTINGS window, and define

the default settings for the pumps.

12. Set hardware settings for Dosing Devices.

13. Define the addition or predose solution in the DOSINOS win-

dow.

Installation of 838 Advanced Sample Processor

To automate Electroplating bath analysis with CVS it is possible to

connect an 838 Advanced Sample Processor, a 843 Pump

Station and up to three Dosing Devices (four more with a 846

Dosing Interface) to the 797 VA Computrace stand. Additionally,

up to three Dosing Devices can be connected to the 838 Ad-

vanced Sample Processor via MSB (but they can't be controlled

by the 797 Software in that case). Proceed as follows

1. Switch on the PC.

2. Connect the 797 VA Computrace stand and the 843

Pump Station (Remote 1) using cable 6.2141.290 (see 797

Hardware Manual).

3. Connect the 838 Advanced Sample Processor and the

843 Pump Station (Remote 2) using cable 6.2141.290.

4. Install the accessories on the 838 Advanced Sample Proc-

essor (see 797 Hardware Manual).

5. Connect the Dosing Devices to the 797 VA Computrace or to

the 846 Dosing Interface (or the 838 Advanced Sample Proces-

sor) (via MSB).

6. Connect the 797 VA Computrace stand to the PC (via

USB).

7. Switch on the 797 VA Computrace stand, the 838 Ad-

vanced Sample Processor and the 843 Pump Station.

8. Specify a suitable method at the 838 Advanced Sample Proces-

sor and adjust it if necessary (see 838 Manual).

9. Start the 797 VA Computrace Software 1.3.x.

10. Choose the 838 Advanced Sample Processor for menu

item Sample Processor on the Automation tab of the GEN-

ERAL SETTINGS window, and check the field Relay box /

Pump Station

on the Automation tab of the GENERAL SET-

TINGS window.

11. Make hardware settings for the 838 Advanced Sample

Processor, and define the default settings for the 843 Pump

Station.